![]() ![]() Is constant trickling to 13+V better for batts? a week later, repeat process, sometimes giving the house batt a little charge, as well.īatts are happier than anytime before when on the BIRD. i connect an external battery charger to the screw and ground terminal of house batt and charge chassis at 10 amps/hr for 3 hre, at which time it reads 13.07V. when parked at home, i put house battery disconnect solenoid (lower one in pic) in STORE, open the access door, and remove the positive cable from the house batt.Ībout every week, i open the access door and read 12.75V on the house batt, but about 12.58V for the chassis. both batts are side terminal 'starting batteries' and about 9 mos old. i ran a short wire from the left solenoid chassis terminal to a screw into the wood floor over the house batt. The BIRD device is just behind the house batt which is accessible thru an outside access door. the left large gauge terminal goes to chassis batt and the right goes to house batt. ![]() i took off its small DC power wires and pulled out the 5 amp fuse. it is the upper silvery solenoid in the pic. A while back, after i found the chassis-house solenoid relay part of the Intellec Bidirectional Isolator Relay Delay device (BIRD) was sticking ON like its predecessor also did, i disabled the solenoid. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |